It’s the perfect solution for areas which require the panel to be in a lower position or rooms with high ceilings.
Drill four 2 mm diameter holes in the brackets on the back of the panel as shown in the drawing.
Close Part A using the screw (Part F) with a screwdriver, make sure that Part A is securely fastened to the bracket.
Insert the wire (Part H) into Part B and tighten them with Part A.
Drill four 8 mm diameter holes in the ceiling.
Insert the anchor (Part G) into the holes in the ceiling and fix Part D to the ceiling using the screw (Part E).
Insert the wire (Part H) into Part C, then secure it and close it in Part D. Make sure the remaining part of the wire protrudes from the hole in the side of Part D
Adjust the cable (Part H) to the desired length, you can always adjust the length of the cable by pressing the end of Part C.